function googleTranslateElementInit() { new google.translate.TranslateElement({pageLanguage: 'en', layout: google.translate.TranslateElement.InlineLayout.SIMPLE}, 'google_translate_element'); }
Call: 800.323.7790 | |  
ATC CHAIN HP-T TYPE WITH TOOL HOLDER
HP-T type ATC chain is based on the HP type with steel tool holder. The inner diameter of the pin is tapered and a retaining function is installed on the pin.
Economical: Additional installation of the tool holder is not necessary.
Accurate holding: As the tool holder is combined with the chain, backlash is reduced.
Compactness: Pin outer diameter and link plate width are smaller than those of HP type.
1) U.S. Tsubaki standardized ATC chain is designed with pull stud, key, number plate and plastic sleeve. An engineering plastic sleeve is fitted to prevent contact with the metal taper parts and protect the shank from being scratched.
2) Attachment chains other than the listed ATC chain line-up are also available to satisfy your special requirements.
1 - 5 of 5 | Results Per Page | View | Unit of Measure
1 

Item #

Shank Number

P - Pitch

R - Roller Diameter

W - Width Between Roller Link Plates

T

H

HP-T-40-3.543 N/A 40 N/A 3.543 in N/A 2.362 in N/A 2.362 in N/A 0.157 in N/A 3.288 in
HP-T-40-3.937 N/A 40 N/A 3.937 in N/A 2.362 in N/A 2.362 in N/A 0.157 in N/A 3.288 in
HP-T-50-5.118 N/A 50 N/A 5.118 in N/A 2.362 in N/A 2.362 in N/A 0.157 in N/A 3.288 in
HP-T-50-5.512 N/A 50 N/A 5.512 in N/A 3.228 in N/A 3.228 in N/A 0.248 in N/A 4.252 in
HP-T-50-6.299 N/A 50 N/A 6.299 in N/A 3.228 in N/A 3.228 in N/A 0.248 in N/A 4.252 in
1 - 5 of 5 | Results Per Page | View | Unit of Measure
1 
^